posted 10-06- 05:02 AM
I have access to a machine at work, and nothing much to do at lunchtime....Unfortunately, it runs NT4 and with the service pack it has, only runs directx3 for NT. No good for OPS. Is there any way of getting round this?
Ineed to do some serious OPS work to site all the inertia boxes and re-do the DOF's on the B24. The modelling is nearly done to my satisfaction, and every time I export and build an OL file, the properties get screwed up.
This one ended up with DOF's all over the place, all the inertia boxes on top of each other, and a complete lack of flight ability!
It was built on a modded lanc base, so it should fly like a lanc....not perform a slow spiral straight down!
FSIC Messageboard
UBBFriend: Email This Page to Someone! 
posted 10-06- 05:02 AM
