FSIC Messageboard   Tech Talk   OPS question: How can I...    profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone!

next newest topic | next oldest topic

Author Topic:   OPS question: How can I... Diego Lozano Pilot posted 06-13- 12:54 AM                When cutting/pasting a prop, how can you keep it from rotating on an eccentric axis? I'm getting rid of the Fw190 prop and adding a donor from the F4f(no nose cone). This will make the "fake" Macchi 200 at least look better. IP: Logged Tailslide Pilot posted 06-13- 12:58 AM                Select the prop, go into DOF mode in opstudio and move the DOF for the prop it so it is centered in the propeller. TS IP: Logged Bryan Russell Pilot posted 06-13- 01:20 AM                Also, if you made the prop so that the axis was centred about the co-ord origin then you can just press the align dof to origin button. Its on the toolbar beside some other doffy looking buttons. ------------------ IP: Logged Diego Lozano Pilot posted 06-13- 09:25 PM                Thanks guys, I'll try it out tonight! Now if I could only get that SpitIX into OPS without crashing.... IP: Logged

All times are CT (US)	next newest topic | next oldest topic
Administrative Options: Close Topic | Archive/Move | Delete Topic
	Hop to: Select a Forum List of Forums: Category: FS - The Game --------------------SDOE GeneralHelp / FAQAfter Action ReportsFS SitesSquadronsWWI in SDOE Category: OpenPlane --------------------Tech TalkOld Tech InfoBibliographyDownloads Section Category: The Playground --------------------Flame WarsJade's PlaypenOff Topic Category: The Site --------------------Site StuffSite AnnouncementsTop Secret

(This site Copyright (c) 1999 Inertia LLC)

Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45c