posted 08-21- 09:55 AM               

Anyway, I set about to adjust the explosion values to see if I could get it to take damage the same as it used to in patch 1.5.

In doing this I noticed the obhits values for the tail section were set lower than the values I had wanted to be used in pp6.1. The tail section just comes off too easy currently even with only .303 bullets. Maybe it is only the p51 which is like this?
Maybe it was modified between the time I put in the obhits values and when pp6.1 came out?
I can't check just now as I am at work.

The obhits are very easy to change on one plane but hopefully is not being changed on all the Dime project planes. The good news is I have the new p51d taking damage the way it did in patch 1.5(my opinion only)

I am just wondering if you are using pp6.0 as your base or pp6.1? Maybe the obhits values are being reset for another reason which I don't know about?

Thanks,

------------------
Condor out

posted 08-21- 12:25 PM               

As for explosion strengths, I've done alot of work in this area (as probably you have) and I've found a strength no greater than 0.0001 should be used, a visible explosion of 30 or so is OK with this size explosion. Anyway, let me know if you got the mail.

posted 08-21- 01:10 PM               

Nope, didn't get it so you must have sent it pretty late. I am sure I will get it tonight.